Hi folks -- on Sunday Tony and I (mostly Tony) got to work on finishing the rear end swap on his 1967 Cougar. The above 8.8 came out of a 1998 Ford Explorer and was modified by taking off existing brackets and then welding new ones on to match the configuration of the Cougar. Particular attention was paid to make sure the brackets are properly spaced and that the pinion angle was correct. Once this job is done it is on to the engine rebuild. A good looking rear end! Installing a Ford 8.8 inch rear end into the 1967 Cougar
Hi folks -- on Sunday Tony and I (mostly Tony) got to work on finishing the rear end swap on his 1967 Cougar. The above 8.8 came out of a 1998 Ford Explorer and was modified by taking off existing brackets and then welding new ones on to match the configuration of the Cougar. Particular attention was paid to make sure the brackets are properly spaced and that the pinion angle was correct. Once this job is done it is on to the engine rebuild. 
Subscribe to:
Post Comments (Atom)
0 comments:
Post a Comment